There are many reasons why you might need to clean a bathtub. Maybe you want to freshen up your bathroom, or maybe it’s just time for a new coat of paint on the tub. Whatever the reason is, this article will give you all the information that you need in order to complete this task with ease and success.
How To Clean A Bathtub Step By Step
Step One: Prepare the Area
The first thing that you want to do before starting any type of project is to gather all of your necessary tools and items.
In this case, we will need a bucket filled with either hot or cold water (depending on how dirty it is), dish soap, a scrub brush, paper towels, gloves if desired, an old toothbrush for getting into tight spaces like around the handles and faucet fixtures.
Make sure that there are no children in the bathroom while working because they might think it’s fun to get in the bathtub when it’s wet- not good! If possible use earplugs as well because cleaning products can be quite loud.
Dry off any parts of the tub where water has collected and use a dry cloth to wipe away any debris or dust from the shower area. Make sure that all of the surfaces are clean before you start cleaning anything else because spilled water can make it harder to see dirt on any surface.
Step Two: Clean Up The Outside
Start by scrubbing down the outside edges with your brush full of hot or cold water and dish soap, concentrating heavily around hard-to-reach places like underneath faucets and handles where bacteria are most likely to accumulate.
Once these areas have been cleaned, move onto wiping off grout lines in which mildew may grow between tiles using a microfiber towel dampened with warm soapy water followed by very hot tap water (scrub lightly if necessary).
Now that the outside is clean, it’s time to move on to cleaning the inside of your tub.
For the final step, fill your tub with water as hot or cold as you like and add bleach. The mixture should be about a gallon of water to every tablespoonful of bleach (or 16 ounces).
Let it stand for an hour before draining out the dirty bathwater into a bucket in order to dispose of it safely. Rinse well again if necessary then pat dry any remaining surfaces–you’re done!
How to clean a Shower?
Clean your shower with a soft-bristled brush, hot soapy water, and clean clothes, and don’t forget the corners! Rinse it off well.
You can use an old tooth brush for any tough spots or scrub away soap scum from grout (try this after you’ve sprayed vinegar on the area).
The final step is using bleach: mix about 16 ounces of chlorine bleach per gallon of warm water in order to kill bacteria as you wipe down all surfaces before they dry. Dry them with a towel then rinse again if necessary until there’s no more smell left behind.
If you have hard water stains around your tub or pedestal sink, try soaking some kitty litter in white distilled vinegar and cover it with a towel overnight.
The next morning, use coarse salt or baking soda to scrub away any lingering stains and then rinse it off with water.
Always dry your tub using a clean cloth and don’t forget the drain!
There’s no one right answer for how often you should be cleaning your bathtub but most people say once every two weeks is good enough (especially if you have kids).
When can I stop worrying about mold?
If there isn’t visible evidence of mold in your bathroom (i.e., black spots), look around on surfaces where condensation accumulates and turns into mildew: under the toilet rim and between tiles just below the showerhead are common places that do not get properly cleaned. These areas should be cleaned with bleach.
What is the best way to remove soap scum from a bathtub?
You can buy cleaners specifically for this purpose, but most people use distilled vinegar and water just mix in one part of each ingredient into four parts of lukewarm water.
Apply it with an old toothbrush or sponge then wipe off any residue left behind before rinsing it away with clean water.
How often should I replace my shower curtain liner?
That depends on how many people are using your tub/shower; if it’s just you, every few months might be sufficient but if there are more of you bathing/showers going on in that space, consider doing so after each one!
- Measures 72 in width and 72 in length. The standard size is sure to fit most bathtubs and...
- Includes free hooks and easy to install and slide. Each shower curtain has 12 rustproof metal...
- Waterproof material. It can be cleaned with a quick rinse or wipe after a shower. And color...
- Printed with unique pattern, drapes gives a clean fresh & eye-catching look in your bathroom.
- It can be cleaned with a quick rinse or wipe after a shower. The curtain is also...
It’ll make cleanups much easier. In addition, keeping the surface behind scrubbed free from gunk is also helpful for water flow.
If you leave your curtain open during daytime hours when natural light penetrates the bathroom, once every five years will do just fine (although some say three).
If not, change it year-round because mildew buildup occurs quickly on fabric that isn’t airy, which is the case with a closed curtain.
How do I remove calcium deposits?
Use vinegar or lemon juice and baking soda to make a paste, then scrub away at it with an old toothbrush until you’ve removed as much of it from the surface as possible before rinsing clean.
What’s the best way to prevent mold in my shower?
It should go without saying that if your bathroom isn’t getting good circulation (or ventilation), use a fan for togetherness sake!
Beyond that, keep any soap scum off the walls by using squeegees instead of sponges; dry off all surfaces after each bath/shower; replace mildewy towels frequently every day would be better than less, and fix any leaky faucets.
What should I do about a rusty bathtub?
Use an acid-free cleaner to remove rust, then use steel wool or sandpaper to take off the finish before painting with stove paint (read up on this first metal will react differently).
How do I prevent soap scum from forming in the bathtub?
Use a squeegee to remove excess water and dry with a towel before soaping up this will help reduce surface tension that can lead to the formation of soap scum.
What are some good natural cleaning products or homemade cleaners for my tub? Vinegar is an effective and inexpensive option; add it if you have hard water (or, dilute half-and-half vinegar/water).
Dishwasher detergent also works well when mixed with hydrogen peroxide. A paste made of baking soda and vinegar may be applied directly onto the stained area then scrubbed clean before rinsing off completely.
After bathing, wipe down surfaces while they’re still wet this will prevent soap scum from drying on the surface.
Are there any products I can buy to clean my tub for me? Yes, but they’re not a cost-effective option in most cases as you’ll need to use quite a few items each time to cover all of your surfaces and keep them sparkling.
A more practical solution is simply lots of elbow grease: go ahead and scrub your bathtub with detergent or baking soda then rinse it off well before taking care of other tasks required around the house!
How do I remove mildew stains once they’ve formed?
Combine vinegar with salt (or lemon juice) into a thick paste which should be rubbed onto the stain using an old toothbrush or dishcloth. Let it sit for a few minutes before scrubbing the mixture off with your fingers.
How often should I clean my bathtub?
This largely depends on how much use it gets in your household: if you’re cleaning and disinfecting it after each time someone uses the tub then once every month or so is more than enough, but if nobody has showered within those four weeks an annual deep-clean could be in order!
This is too hard – can’t I just hire somebody to do this for me instead? Yes–although depending on where you are (and who’s available) housekeepers might charge as little as $75 an hour while professional cleaners will cost hundreds of dollars per visit.
The good news is that they have all sorts of tools and equipment at their disposal which can make the job much easier.
How do you deep clean an old bathtub?
The first step is to strip it down. This means that all of the fixtures need to be removed and scrubbed or replaced: this includes things like taps, shower fittings, soap dishes/holders, etc.
You’ll also want a bucket with soapy water for cleaning surfaces and removing stubborn dirt spots which might have accumulated over time.
If you’re worried about how much bleach will damage the finish on your tub (or whether there’s still lead on its surface), then make sure to use white vinegar instead–it can get rid of stains without permanent alterations!
I’m looking at my old bathtub right now – does anything look really gross?
For example… mold growing around the drain hole, rust-colored patches near brass fixtures, brown stains where the overflow drain is located? If you see something like that then it’s likely a sign that your tub needs to be replaced.
How do I clean the gunk out of my bathtub??
First, scrub the outside of the tub with a mixture of vinegar and water. To get rid of stubborn dirt or hard-to-reach stains inside your bathtub, pour some dish soap into an old bucket filled with hot soapy water.
Put on gloves before you start to clean (unless you want icky goo all over your hands) then use this cleaning solution on any surface that needs attention!
How do you clean a bathtub without scrubbing?
Hiring a professional cleaning company to do the job for you! You can either contact your local cleaners or use an online service. Either way, it’s one less thing that you have to worry about and more time spent on other things in life.
Does vinegar clean bathtubs?
Yes! Vinegar is a great natural cleaner and it’s inexpensive. Plus, vinegar leaves your bathroom smelling really fresh after the job is done!
How to clean a bathtub with bleach?
Mix one part bleach with three parts water, and apply the mixture to a clean cloth. Wet it with some vinegar first if you want an extra streak-free finish!
How to clean the bathtub with baking soda?
To make a paste, mix together one tablespoon of baking soda with enough water to form the desired consistency. Clean the surface in sections and rinse well after scrubbing for best results!
Home remedy for cleaning bathtub?
Vinegar and baking soda make a great natural bathtub cleaner. Mix one part vinegar with three parts water, or use baking soda on its own to scrub away stains in the tub. It’s also best to clean it as soon as you notice any built-up grime!
How long should I wait before showering after cleaning my bathtub?
You can start using your shower again within an hour of cleaning your bathroom if there are no other chemicals present that might cause irritation. However, for complete safety, we recommend waiting at least eight hours before taking a dip in the tub.
Bathtub Cleaning Tips
If you don’t have a dishwasher or washing machine handy, rinse off your bathtub with water and use an abrasive scrubber to eliminate soap scum.
The process of how to clean a bathtub can seem intimidating. After all, it’s hard enough to keep your own home in order without having to worry about scrubbing down the tub after every use.
And yet, keeping up with this daily task is an important part of owning a house or apartment! So if you’re feeling overwhelmed and don’t know where to start when faced with cleaning out your dirty bathroom fixtures, we have some tips for you that will make taking care of the grime easier than ever before.
First off: what tools are necessary?
You’ll need soap, vinegar (or baking soda), sandpaper or steel wool pads, scouring brushes like those used on dishes or pots and pans; a razor blade; an old toothbrush (or a clean one); and paper towels.
Before you start, it’s important to have everything handy in the tub so that nothing falls out of reach.
Next: what should be done first?
Some people will say that scrubbing away at soap scum is the most difficult task when cleaning your bathtub- but if you follow our advice for how to clean a bathtub properly, this step won’t even need doing! So skip ahead to Step Three below if you want.
Finally: What can I do about rust stains on my porcelain bathroom fixtures?
The best way we’ve found to remove these stubborn spots are heavy-duty metal polish sprays or cream cleaners- just make sure to test them on a small, visible area first before applying it over the entire bathtub.
And when you’re done scrubbing and polishing? Wipe down with paper towels or rags (or even your old toothbrush!)
Step One: Clean The Grout Lines Between Your Tile In A Bathroom. Sprinkle baking soda along the grout lines and let sit for 15 minutes. Brush away any particles that remain using an old toothbrush
Step Two: Scrub Away Soap Scum With An All-Purpose Cleaner. Mix together one tablespoon of dish soap with two tablespoons of all-purpose cleaner in a spray bottle filled halfway up with warm water; then shake well before spraying onto the tub and scrubbing with an old toothbrush.
Step Three: Make It Shine With A Metal Polish. Spray the metal polish on a rag or paper towel and wipe down your tub in circular motions for best results. Then, buff it clean by wiping it in one direction to remove any excess.
How do I clean my tub after someone peed in it?
Cleaning up the aftermath of one who has been wild is never fun but there are ways that make it less messy.
For starters, add two cups of baking soda for every quart of warm vinegar into the tub before soaking it all away! It’s also best if you can get the person responsible to help out as well!
Was this helpful?
0 / 0
Last update on 2022-05-28 at 21:43 / Affiliate links / Images from Amazon Product Advertising API#How do I remove calcium deposits #How To Clean A Bathtub #How to clean a Shower #What is the best way to remove soap scum from a bathtub #What's the best way to prevent mold in my shower #When can I stop worrying about mold